Woodward DTSC-200A - More LED Indicators and Push Buttons; LED Indicators and Push Button Functions

Manual 37941A DTSC-200A - ATS Controller - Operation
© Woodward Page 7/37
15
LED S2 ok
The LED indicates that the source S2 is okay according to the configured operating ranges.
16
LED Bypass possible
The LED indicates that the current sequence timer is possible to be bypassed. The current se-
quence timer is indicated on the Home Page View.
17
LED Settings mode entered
The LED indicates that the settings mode is entered. To leave the settings mode you must push
the Go-Back
11
Button.
18
LED LOAD TEST
The LED indicates that the LOAD TEST is currently manually initiated.
19
LED ENGINE TEST
The LED indicates that the ENGINE TEST is currently manually initiated.
20
Push Button BYPASS
If the LED Bypass possible
16
is flashing the operator can push this button to bypass a current
timer for example a stable timer.
21
Push Button SETTINGS
This button brings the operator directly into the settings mode. The settings mode is indicated
with the flashing LED Settings mode entered
17
. From there on the buttons on the right tot he
display are used to navigate through the settings menus.