Woodward DTSC-200A - Engine Test Operation

Manual 37941A DTSC-200A - ATS Controller - Operation
© Woodward Page 9/37
23
Push Button ENGINE TEST
With this button the operator can manually initiate the ENGINE TEST sequence. Once pushed
he must confirm over display whether he want to start the ENGINE TEST [No Load Test] with
all its consequences.
Confirming
No Confirming
With confirming over the return button, the manually ENGINE TEST is initiated and the LED
ENGINE TEST
19
will flashing.
If the LED ENGINE TEST
19
is flashing the operator can abort the ENGINE TEST by pushing
the ENGINE TEST button again. With doing that he must confirm again to interrupt the
ENGINE TEST [No Load Test].
Confirming
No Confirming
If he confirms the abort of the engine test the LED ENGINE TEST
19
will be off and the
DTSC-200A goes into the normal operation.