• Use only the transport devices to move the equipment. Never use the
guards for handling or moving the equipment. Handle openings for
transport purposes are on both sides of the saw housing.
• While you are moving the machine it is best to cover the top part of
the blade, e.g. with the guard.
• Prevent long workpieces from falling off the end of the cut by using a
roller stand etc.
1.2.4. Additional instructions
• Give these safety instructions to all persons who work on the machi-
ne.
• Do not use this saw to cut fire wood.
• Do not use this saw to cross-cut roundwood.
• Caution! Hands and fingers may be injured on the rotating saw blade.
• The machine is equipped with a safety switch to prevent it from
being switched on again accidentally after a power failure.
• Before you use the machine for the first time, check that the voltage
marked on the rating plate is the same as your supply voltage.
• If you need to use an extension cable, make sure its conductor cross-
section is big enough for the saw‘s power consumption. Minimum
cross-section: 1 mm².
• If you use a cable reel, the complete cable must be pulled off the reel.
• Check the power cable. Never use a faulty or damaged power cable.
• Operators have to be at least 18 years of age. Trainees of at least 16
years of age are allowed to use the machine under supervision.
• Keep your workplace clean of wood scrap and any unnecessary ob-
jects.
• Persons working on the machine should not be distracted.
• Note the direction of rotation of the motor and saw blade.
• After you have switched off the motor, never slow down the saw bla-
de by applying pressure to its side.
• Only fit blades which are well sharpened and have no cracks or defor-
mations.
• Never dismantle the machine‘s safety devices or render them inope-
rative.
• Faulty saw blades must be replaced immediately.
WZTS_1700_AUS_SPK7.indb 10 21.05.12 15:54
To Next Page
Loading...
Need help?
General
