Protect yourself and your environment from risks and accidents by taking
the appropriate precautionary measures.
• Do not look directly into the laser beam with the naked eye.
• Never look directly into the laser path.
• Never direct the laser beam at reflecting surfaces or persons or ani-
mals. Even a low output laser beam can inflict injury on the eye.
• Caution: It is vital to follow the work procedures described in these
instructions. Using the equipment in any other way may result in ha-
zardous exposure to laser radiation or radioactive contamination.
• Never open the laser module.
Use of the batteries
• Ensure that the ON/OFF switch for the laser (32) is set to its “0” positi-
on before you fit the batteries.
• Inserting the batteries when the laser is switched on can cause acci-
dents.
• If the equipment is not used correctly the batteries may leak. Avoid
contact with the battery fluid. If you come into contact with battery
fluid, clean the affected body part with running water. If you get bat-
tery fluid in your eyes, seek immediate medical assistance.
• Leaked battery fluid can cause skin irritation and acid burns.
• Never expose the batteries to excess heat such as direct sunlight or
fire etc.
• Never recharge batteries that are not suitable for recharging. There is
a risk of explosion!
• Keep batteries away from children, do not short circuit batteries or
disassemble.
• Seek a doctor’s advice immediately if a battery is swallowed.
• If necessary, clean the contacts on the battery and equipment before
inserting the batteries.
• Ensure that you insert the batteries correctly.
• Remove flat batteries immediately from the equipment. There is an
increased risk of leakage.
• Always change all batteries at the same time.
WZTS_1700_AUS_SPK7.indb 5 21.05.12 15:54
To Next Page
Loading...
Need help?
General
