19. Check the equipment for damage
- Before using the tool again, check the safety devices or any slightly
damaged parts to ensure that they are in good working order. Check
that the moving parts are working correctly, that they do not jam,
and that no parts are damaged. Make sure that all parts are fitted cor-
rectly to ensure that the equipment remains safe to use. Unless other-
wise stated in the operating instructions, damaged guards , damaged
switches and parts have to be repaired or replaced by an authorized
technician. Never use tools with a switch that cannot be turned on
and off.
20. Important!
- For your own safety you must only use the accessories and additi-
onal units listed in the operating instructions as recommended or
specified by the manufacturer. The use of mounted tools or accesso-
ries other than those recommended in the operating instructions or
catalog may place your personal safety at risk.
21. Repairs may only be carried out by a qualified electrician
- This electric tool complies with the pertinent safety regulations. Re-
pairs are to be carried out only by a qualified electrician using original
replacement parts or the user may suffer an accident.
22. Connecting a vacuum dust extraction system
- If there are provisions for connecting a vacuum dust extraction sys-
tem, make sure that such a system is fitted and in use.
1.2. Special safety information
1.2.1. Safety precautions
• Blades that are deformed or cracked must not be used.
• If the table insert is worn, replace it.
• Use only blades which are recommended by the manufacturer and
comply with EN 847-1. When changing the blade, make sure that the
cutting width is not smaller and the saw plate not bigger than the
thickness of the splitter.
• Make sure that the chosen blade is suitable for the material that is to
be cut.
WZTS_1700_AUS_SPK7.indb 8 21.05.12 15:54
To Next Page
Loading...
Need help?
General
