9. Wear safety goggles.
- Use a dust mask when working on dusty jobs.
10. Do not use the cable for purposes other than that for which it is
designed
- Do not carry the tool by its cable and do not use the cable to pull
the plug out of the socket. Protect the cable from heat, oil and sharp
edges.
11. Secure your workpiece
- Use clamps or a vice to hold the workpiece securely. This is safer
than using your hands and also enables you to operate the machine
with both hands.
12. Avoid abnormal working postures
- Make sure you stand squarely and keep your balance at all times.
13. Take care of your tools
- Keep your tools sharp and clean in order to work well and safely. Fol-
low the maintenance information and the instructions for changing
tools. Check the power plug and cable on a regular basis and have
them replaced by an authorised specialist if they are damaged. Check
the extension cable regularly and replace it if damaged. Keep handles
dry and free from oil and grease.
14. Disconnect the power plug
- When tools are not in use, before starting any maintenance work
or when changing attachments such as saw blades, drill bits and all
kinds of mounted tools.
15. Always remove keys and wrenches after use
- Before switching on the machine, make sure that all keys and wren-
ches have been removed from the equipment.
16. Avoid unintentional starting
- Never carry a tool with your finger on the switch button while the
tool is connected to the power supply. Make sure that the switch is
turned off when connecting the tool to the power supply.
17. When using an extension cable outdoors
- Check that it is approved for outdoor duty and is marked accordin-
gly.
18. Be alert at all times
- Keep an eye on your work. Use common sense when working. Never
use the tool when you are distracted.
WZTS_1700_AUS_SPK7.indb 7 21.05.12 15:54
To Next Page
Loading...
Need help?
General
