7
Data
Technical data
AC motor ................................................................................................... 240 V ~ 50 Hz
Power P ................................................................................................... S6 40% 1700 W
Idle speed n
0
.................................................................................................. 6,500 min
-1
Carbide saw blade Ø 250 x Ø 30 x 2.4 mm .............................................. 24 teeth
Carbide saw blade Ø 250 x Ø 30 x 3.0 mm .............................................. 48 teeth
Table size ................................................................................................... 610 x 445 mm
Table width extension, left/right ..................................................... 608 x 250 mm
Table length extension, rear ............................................................... 435 x 320 mm
Max. cutting height .................................................................................. 72 mm / 90°
.......................................................................................................................... 54 mm / 45°
Height adjustment .......................................................................... infinite 0 - 72 mm
Tilting saw blade .................................................................................. infinite 0° - 45°
Dust extraction connector ........................................................................... Ø 36 mm
Weight ..................................................................................................... approx. 28.2 kg
Operating mode S6: Continuous operation
To prevent the motor from overheating, only use the bench-type circular
saw as follows:
After an operating period of 4 minutes (S 6 = 40%) under the permitted
load, you must interrupt your work for a period of 6 minutes in which the
machine can run idle.
Noise emission values
The noise emission values were measured in accordance with
EN 61029-2-1.
On-load operation
L
pA
sound pressure level ................................................................................. 96 dB(A)
K
pA
uncertainty .......................................................................................................... 3 dB
L
WA
sound power level ................................................................................... 114 dB(A)
K
WA
uncertainty .......................................................................................................... 3 dB
WZTS_1700_AUS_SPK7.indb 40 21.05.12 15:57
To Next Page
Loading...
Need help?
General
