Cleaning and maintenance
Important! Always pull out the power plug before starting any
cleaning work.
Cleaning
• Keep the safety devices free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it down with compressed
air at low pressure.
• We recommend that you clean the equipment immediately after you
use it.
• Clean the equipment regularly with a damp cloth and some soft
soap. Do not use cleaning agents or solvents; these may be too harsh
and can corrode the plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.
Carbon brushes
In case of excessive sparking, have the carbon brushes checked by a qua-
lified electrician. Caution! Only a qualified electrician is allowed to replace
the carbon brushes.
Disposal and recycling
The equipment is supplied in packaging to prevent it from being da-
maged in transit. The raw materials in this packaging can be reused or
recycled. The equipment and its accessories are made of various types of
material, such as metal and plastic. Defective components must be dispo-
sed of as special waste. Contact your manufacturer or your local council
for further information.
WZTS_1700_AUS_SPK7.indb 42 21.05.12 15:57
To Next Page
Loading...
Need help?
General
