• Operate the saw only with a suitable vacuum dust extraction system
or a standard industrial vacuum cleaner.
• Never remove loose splinters, chips or jammed pieces of wood when
the saw blade is running.
• To rectify faults or remove jammed pieces of wood, always switch off
the machine first.
- Disconnect power plug
• If the sawing gap is worn, replace the table insert.
- Disconnect power plug
• This tool complies with the pertinent safety regulations.
• Keep the tool out of the rain and away from moisture. The ingress
of water into an electric power tool increases the risk of an electric
shock.
• Be careful, watch what you are doing and use an electric tool sensib-
ly. Never use the tool if you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention when using the elec-
tric tool can result in serious injuries.
• Do not use an electric power tool if the switch is defective. An electric
power tool that cannot be switched on or off is dangerous and must
be repaired.
• Keep unused electric tools out of the reach of children. Do not allow
people who are not familiar with the tool or who have not read these
instructions to use the tool.
• Electric tools are dangerous if they are used by inexperienced people.
• Keep your cutting tools sharp and clean. Carefully maintained cutting
tools with sharp cutting edges will jam less and are easier to control.
• If the power cable for this equipment is damaged, it must be replaced
by the manufacturer‘s after-sales service or by similarly trained per-
sonnel to avoid danger.
• Have your tool repaired only by trained personnel using only genuine
spare parts. This will ensure that your tool remains safe to use.
• The equipment has to be set up where it can stand securely.
• All covers and safety devices have to be properly fitted before the
equipment is switched on.
• It must be possible for the blade to run freely.
• When working with wood that has been processed before, watch out
for foreign bodies such as nails or screws etc.
WZTS_1700_AUS_SPK7.indb 12 21.05.12 15:54
To Next Page
Loading...
Need help?
General
