wtw pH 7310 - Resetting the System Settings

pH 7310 Settings
ba75929e02 10/2011 45
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open it, press the <F1>/[Menu] or
<ENTER> key in the measured value display.
7.4.2 Resetting the system settings
The following system settings can be reset to the default condition:
The system settings are reset in the menu, Storage & config / System / Reset.
To open the Storage & config menu, press the <F1_>[Menu] key in the
measured value display.
Measured parameter pH
Resolution pH 0.001
Resolution mV 0.1
Asymmetry 0 mV
Slope -59.2 mV
Man. temperature 25 °C
One point calibration No
Stability control On
Temperature unit °C
Setting Default settings
Language English
Beep On
Baud rate 4800 Baud
Output format ASCII
Contrast 50 %
Illumination Auto
Switchoff time 1 h
Setting Default settings