wtw pH 7310 - Erasing the Measurement Data Storage; Measurement Dataset; Storage Locations

pH 7310 Data storage
ba75929e02 10/2011 51
Quitting the display To quit the display of stored measurement datasets, you have the following
options:
 Switch directly to the measured value display with <M>.
 Quit the display and move to the next higher menu level with <F1>/[Back].
8.3.2 Erasing the measurement data storage
Erasing the measurement data storage (see section 8.3.1 EDITING THE
MEASURED VALUE STORAGE, page 49).
8.3.3 Measurement dataset
A complete dataset consists of:
 ID number
 Date/time
 Measured value of the connected sensor
 Measured temperature value of the connected sensor or manually set tem-
perature
 AutoRead info: The AR indicator appears with the measured value if the
AutoRead criterion was met while storing (stable measured value). Other-
wise, there is no AR indicator.
 Calibration evaluation: +++, ++, +, -, or no evaluation
8.3.4 Storage locations
The pH 7310 meter has two measurement data storages. The measured
values recorded either manually or automatic are stored separately in indi
-
vidual measurement data storages.
Storage Maximum number of datasets
Manual data storage 500
Automatic data storage 5000