Xantrex Freedom SW Series User Manual

97-0019-01-01 49
Configuring the Freedom SW using the SCP
An overview of the Freedom SW menu structure is shown
below. The SCP displays the Freedom SW basic settings
menu.
Figure 23 Menu Map of the Freedom SW Basic Settings
FSW3012 00: Setup
Mode
Battery
Load
AC In
Inverter
Search Mode
Charger
Force Chg State
Equalize
Desired Mode
Clear Faults Warnings
View Device Info
Basic Settings
Invert
11.8V -88.0A N/A
915W 120V 7A
0V 0A 0Hz
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Standby]
StatusConfigurable Settings
FSW3012 00: Dev Info
View Fault Log
View Warning Log
View Event Log
FSW3012 00: Basic Settings
Batt Type
Batt Capacity
Max Chg Rate
Charge Cycle
ReCharge Volts
AC In Breaker
Low Batt Cut Out
[Flooded]
[440Ah]
[100%]
[3-Stage]
[12.5V]
[30A]
[11.0V]
[*Enabled] [Disabled]
[*Disabled] [Enabled]
[*Disabled] [Enabled]
[*No Float] [Float] [Bulk]
[Disabled]
[*Standby] [Operating]
[*Flooded] [Gel] [AGM] [Custom]
[*3-Stage] [2StgNoFloat]
Follow procedures on “To select and change a
configurable setting:” on page 43 to change the settings.
FSW Owners Guide.book Page 49 Tuesday, August 7, 2018 9:03 AM

Xantrex Freedom SW Series Specifications

General

Output Voltage	120 VAC
Output Frequency	60 Hz
AC Transfer Switch	Yes
Battery Charger	Yes
Input Voltage	12V, 24V, 48V DC
Protections	Over temperature, overload, short circuit