Xerox 770 - Page 258

Recommended solutionPossible causeFault
code
A top cover is open.013-303
013-304
1.
Open the Top Left and Right Covers of the
SquareFold Trimmer Module.
2.
Close the SquareFold Trimmer Module Top
Left and Right Covers.
3.
If fault persists, power off/on the machine.
4.
If fault persists, call for service.
The Trimmer Waste Container is full
or has a fault.
013-208
013-940
013-941
1.
Pull open the container and empty any
trimmer scraps from it.
2.
Reinsert the container into the SquareFold
Trimmer Module.
3.
Ensure that the container is fully pushed in,
and that the indicator light is not lit.
4.
If fault persists, repeat Steps 1-3.
5.
If fault persists, power off/on the machine.
6.
If fault persists, call for service.
Booklet Tray on the SquareFold
Trimmer Module is full.
013-943
1.
Remove any booklets from the tray.
2.
If fault persists, power off/on the machine.
3.
If fault persists, call for service.
Finisher jam or fault012-115
012-264
012-302
1.
If machine’s UI continues to reflect a
fault/jam, open the finisher and remove any
jams.
Close the finisher cover(s).
2.
Follow the instructions shown on the
machine’s UI to resume printing.
3.
If fault persists, power off/on the machine.
4.
If fault persists, call for service.
Xerox
®
770 Digital Color Press
17-18
User Guide
SquareFold Trimmer Module
(continued)