Windows 95/98 print drivers 3. Network Setup
Xerox DocuColor 2006 3-5
Windows 95/98
Before you begin
1. Ensure that the DocuColor 2006 has been prepared for network printing.
2. Ensure that you have the printer name, Apple Talk Zone (if applicable),
and IP Address. These may be obtained from your system administrator
or from the Configuration Page.
In order to print the Configuration Page, perform the following steps:
a. Press the Offline button on the Printer Control Panel
b. Press the Menu button until the message Print Pages from List is
displayed on the Printer Control Panel.
c. Press the Item/Enter button in order to select Print Configuration
Page.
d. Press the Item/Enter again button in order to print the page.
Installing the print driver
The following procedure provides the steps for installing the printer driver for
parallel port printing. For detailed information about setting up IPX/SPX
printing or SMB printing, refer to Installing the user software in a Windows
95/98 environment.
1. Insert the User Software CD in your CD-ROM drive.
2. Select the Start button, Settings, and Printers.
3. Double-click the Add Printer and select Next.
4. Select Local printer and Next.
5. Select the Have Disk button.
6. Perform one of the following:
• If you are installing from the CD, select the CD-ROM drive (for
example, D:\) from the drop-down box and select the Browse
button.
• If you are installing from files you downloaded using the Installer
WebTool, type the name of your hard disk drive (for example, C:\)
and select the Browse button.
To Next Page
Loading...
Need help?
General
