Xerox I Class User Manual

90 I-Class
If experiencing this problem… Try this solution…
Erratic printing (instead of the
label format, strange characters
are printed):
• The printer may be in Hex Dump Mode;
see Section 6.2.
• If using the serial port for communicating,
check both the host and printer port
settings; the printer may be set to eight
data bits while the host is set to 7 (or vice
versa).
Intellifont

will not print: Intellifont

format is Little/Big Endian
specific. The printer uses Big Endian. Refer
to your font supplier for information.
Light print on the right side
(facing the printer) of the
label:
• The Printhead Leveling Cam may be
incorrectly adjusted; see Section 5.1.1.
• The Platen Roller may be dirty or worn;
see Section 5.3.2.
Missing information in the
printed label:
• Check the label format for character
placement outside the dimensions of the
label; all row/column values must allow
enough space for the height/length of the
characters and bar codes to be printed
within the format size.
• The available memory may have been
exceeded by the memory requirement of
the label format. Try reducing the memory
allocated to either the internal module or
scaleable font caches; see System Settings
/ Memory Settings, Section 4.1.5.
• If using serial communications, ensure that
the interface cable meets the requirements
found in Section 3.0.1.
Missing print on left or right
side of the label:
Information may be formatted outside the
label dimensions. Check your software
program label size or check the values in the
menu for Print Control / Column Offset and
Print Control / Custom Adjustments /
Column Offset; see Section 4.1.3.

Xerox I Class Specifications

General

Brand	Xerox
Model	I Class
Category	Printer
Language	English