I-Class 99
Printer Fault Messages (continued)
Displayed Message Description Possible Solution(s)
The Verifier could
not successfully
pass a bar code.
þ Note: This is a
normal condition
when a bar code is
not verifiable.
Simultaneously press the
ENTER and F1 Keys on the
Verifier to clear. If the fault
continues consult the DMX
2970 Operators Manual.
Warning Messages:
Warning Messages are displayed for a period of five seconds. If multiple
warnings are detected, the display will reflect the highest priority message.
Printer Warning Messages
Displayed Message Description Action(s)
The printer has
detected defective
printhead elements.
Replace the printhead if the
print quality becomes
unacceptable.
The printer measured
only a small
difference between
the ‘empty’ and ‘gap’
sensor readings.
Transparent backing or
notched media typically
gives this indication. In this
case, there may be a slight
delay in the ‘Out of Stock’
indication, after the media
supply is emptied; no
action is required.
Power has been
removed and
shutdown is in
progress.
The printer power switch
was turned ‘Off’, the line
fuse has blown, or AC line
voltage has been lost.
The host has pending
configuration
changes that will not
take effect until a
‘host reset command’
is issued.
To save changes, send a host
reset command (in DPL), or
to discard changes perform a
soft reset; see Section
4.0.6.1.
To Next Page
Need help?
General