Getting Started
Xerox Phaser 4600/4620
User Guide
12
Powering on the Machine
The On/Off switch and the power inlet are at the rear of the machine.
1. Connect the AC Power Cord to the machine and a
power outlet. The power cord must be plugged into a
grounded power socket.
2. Press the ON/OFF switch to the ON (I) position.
3. To power off, press the ON/OFF switch to the OFF (O)
position.
Network Connection
If the machine is to be network connected, follow these steps to connect the network cable.
1. Connect a 10/100/1000 BaseT Ethernet cable to the
Ethernet Port at the rear of the machine.
2. Connect the other end of the cable to your network
port.
The machine will attempt to join the network (this
may take a few minutes).
To configure the Network Settings at the machine, refer to
Network Settings on page 80. For full network installation
instructions, refer to the System Administrator Guide.
1
2
1
2
3
3
To Next Page
Loading...
Need help?
General