8 1 Printer Environment Settings
9. Confirm your selection by pressing the <OK/Eject> button.
The display shows [Reboot to apply settings] for 3 seconds and returns to the setting
screen.
You will reboot the printer after setting the gateway address. Go on to the next step.
10. Press the < > button to return to [Get IP Address].
11. Press the < > button to display [IP Address].
12. Press the < > button to accept the selection.
The current IP address is displayed.
13. Enter the value in the first field using the < > or < > button, and press the < >
button.
Note
• If you do not need to change the setting, press the
< > button to advance to the next field.
• Pressing and holding down the < > or < > button
increments the value by 10.
• To return to the previous field, press the < > button.
14. Enter the rest of the fields in the same manner. After entering the last (4th) field, press
the <OK/Eject> button to confirm your entry.
15. If you want to set a subnet mask and gateway address, press the < > button and
proceed to Step 16.
If you want to finish the setting, proceed to Step 23.
Get IP Address
Panel*
TCP/IP
Get IP Address
TCP/IP
IP Address
IP Address
000.000.000.000*
IP Address
192.000.000.000
IP Address
192.168.001.100*
To Next Page
Loading...
Need help?
General