Xerox Phaser 5500 User Manual

Phaser® 5500 Laser Printer
A-3
Maintenance Safety
■ Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your printer.
■ Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
performance and could create a hazardous condition.
■ Do not burn any consumables or routine maintenance items. For information on Xerox
supplies recycling programs, go to www.xerox.com/gwa
.
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation
of your printer.
Printer Location
Place the printer in a dust-free area within a temperature range of 41° F to 90° F (5° C to
32° C) and a relative humidity range of 15 percent to 85 percent.
Printer Clearance
Place the printer in an area where there is adequate space for ventilation, operation, and
servicing. The recommended minimal spacing is:
Overhead Clearance:
■ 30 cm (12 in.) above the printer without the finisher/stacker
■ 47 cm (18.5 in.) above the printer with the finisher/stacker
Total Height Requirements:
■ Printer: 74 cm (29 in.)
■ Add 29 cm (11.5 in.) for the 1000-sheet feeder
Other Clearances:
■ 20 cm (8 in.) behind the printer
■ 46 cm (18 in.) in front of the printer
■ 50 cm (20 in.) on the left side of the printer
■ 65 cm (26 in.) on the left side of the printer with 2000-sheet feeder
■ 20 cm (8 in.) on the right side of the printer
■ 99 cm (39 in.) on the right side of the printer with the finisher/stacker

Xerox Phaser 5500 Specifications

General

Brand	Xerox
Model	Phaser 5500
Category	Printer
Language	English