Transparencies
Phaser® 5500 Laser Printer
2-48
2. Insert the transparencies (long-edge feed preferred) into Tray 2, 3, 4, or 5.
Note
Do not load paper above the fill line inside the tray.
3. Adjust the paper guides to the size of the transparencies.
4. If prompted at the printer’s front panel, press the OK button to accept the paper size and
type that are highlighted. If you have changed the paper size or type, do the following:
a. Select Change, then press the OK button.
b. Select Transparency, then press the OK button.
c. Select the paper size, then press the OK button to save your selection.
5. In the printer driver, select either Transparency as the paper type or the tray you loaded as
the paper source.
5500-14
To Next Page
Loading...
