Xerox Phaser 7800

Network Configuration
Phaser 7800 Color Printer 21
System Administrator Guide
IP
Internet Protocol (IP) is a protocol within the Internet Protocol Suite that manages the transmission of
messages from computer to computer.
Configuring TCP/IP Settings at the Control Panel
Configuring the IPv4 Network Address Manually
1. At the control panel, touch Printer.
2. Touch the Tools tab, then touch Setup.
3. Touch Network & USB.
4. Touch Ethernet.
5. Touch TCP/IP (v4).
6. Touch On:Static IP.
7. Touch IP Address and type the address using the keypad.
8. Touch OK.
9. Touch Network Mask and type the network mask using the keypad.
10. Touch OK.
11. Touch Gateway Address and type the address using the keypad.
12. Touch OK.
Configuring the IPv6 Network Address Manually
1. At the control panel, touch Printer.
2. Touch the Tools tab, then touch Setup.
3. Touch Network & USB.
4. Touch Ethernet.
5. Touch TCP/IP (v6).
6. Touch Manual.
7. Select the Enable Manual IPv6 check box.
8. To change the Prefix Length, touch Prefix Length and type the prefix length using the keypad.
9. Touch OK.
10. Type the address using the keypad.
11. Touch OK.