Xerox Phaser 7800

Security
Phaser 7800 Color Printer 45
System Administrator Guide
Enabling FIPS 140 Mode and Checking for Compliance
1. In CentreWare Internet Services, click Properties > Security > Encryption.
2. Click FIPS 140-2.
3. Click Enable.
4. Click Run Configuration Check and Apply.
A pass or fail message appears:
 If the configuration check passes, click Reboot Machine to save and restart the printer.
 If the configuration check fails, the reasons for the failed test list in a table at the bottom of the
page. For each reason, a link is provided. Click the appropriate link to disable the protocol,
replace the certificate, or allow the printer to use the non-compliant protocol.
Note: When FIPS 140 Mode is enabled, only FIPS-compliant certificates can be installed on
the printer.