8
Use of an extension cord with this product is not recommended or authorized.
Users should check building codes and insurance requirements if a properly earthed
extension cord is to be used. Ensure that the total ampere ratings of the products plugged
into the extension cord do not exceed the extension cord ampere rating. Also, make sure
that the total amperage of all products plugged into the wall outlets does not exceed the
outlet rating.
Disconnect Device
for this product is the power cord. To remove all electrical power to
the product, disconnect the power cord from the power receptacle.
Your equipment
is equipped with an energy saving device to conserve power when the
machine is not in use. The machine may be left on continuously.
Unplug
this product from the wall outlet before cleaning. Always use materials
specifically designated for this product. Use of other materials may result in poor
performance and could create a hazardous situation.
Do not
use aerosol cleaners. Follow the instructions in the User Guide for proper cleaning
methods.
Never
use supplies or cleaning materials for purposes other than those for which they
were intended. Keep all supplies and materials out of reach of children.
Do not
use this product near water, wet locations, or outdoors.
Do not
place this product on an unstable cart, stand or table. The product may fall,
causing personal injury or serious damage to the product
Slots and Openings
in the cabinet and in the back and sides of the product are provided
for ventilation. To ensure reliable operation of the product and to protect it from
overheating, these openings must not be blocked or covered. The product should never
be located near or over a radiator or heat register. This product should not be placed in a
built-in installation unless proper ventilation is provided.
Never
push objects of any kind into the slots of the product as they may touch dangerous
voltage points or short out parts which could result in a fire or electric shock.
Never
spill liquid of any kind on the product.
Never
remove covers or guards that require a tool for removal, unless directed to do so
in a Xerox approved maintenance kit.
Never
defeat interlock switches. Machines are designed to restrict operator access to
unsafe areas. Covers, guards and interlock switches are provided to ensure that the
machine will not operate with covers opened.
Do not
put your hands into the fuser area, located just inside the exit tray area, as you
may be burned.
Quality Standards:
The product is manufactured under a registered ISO9002 Quality
system.
If you need additional safety information concerning this XEROX product or XEROX
supplied materials you may call the following number:
EUROPE +44 (0) 1707 353434
USA/CANADA 1 800 828 6571
To Next Page
Loading...
