186 Xerox WorkCentre 4260 Series System Administration Guide
Xerox public MIBs are located at: http://ftp.xerox.com/pub/drivers/MIBs/
Customers can download the MIBs and use their SNMP tool to obtain the required
information.
Enable/Disable System Timer Values
To enable or disable any System Timer Value for either of the following must be carried out
on the machine:
• System Time Out
• Incomplete Scan
• Held Job Time Out
At the machine
1. Press the <Log In/Out> button on the machine to enter the Tools Pathway.
2. Enter the Administrator’s Password. The default is 1111.
3. Touc h [Enter].
4. Press the <Machine Status> button.
5. Touc h [Tools].
6. Touc h [Device Settings].
7. Touc h [Timers].
To enable System Time Out
8. Touc h [System Time Out].
9. Touc h [Enable], to set the timer to indicate when user selections will return to their
default settings.
10. Select the timer value (1 and 10 minutes) by touching the UP and DOWN arrow.
11. Touc h [Save] to return to the Timers menu.
To enable Incomplete Scan
12. Touc h [Incomplete Scan].
13. Touc h [Enable], to set the timer to indicate when to delete an incomplete scan job.
14. Select the timer value (1 and 10 minutes) by touching the UP and DOWN arrow.
15. Touc h [Save] to return to the Timers menu.
To enable Held Job Time Out
16. Touc h [Held Job Time Out].
17. Touc h [Enable], to set the timer to indicate how long the System will hold incomplete
jobs before automatically deleting them.
To Next Page
Loading...
Need help?
General
