Network Configuration
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
101
Configure FTP
This page allows you to set the File Transfer Protocol (FTP) mode when FTP is selected as the protocol
to be used for network filing services. The following features use network filing services:
• Workflow Scanning
• Reprint Saved Jobs
• Software Upgrades
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to Access Internet Services as System Administrator on page 24.
1. From the Properties tab, click on the [Connectivity] link.
2. Click on the [Protocols] link.
3. Select [FTP] in the directory tree.
4. In the Mode area, select one of the following required modes:
• Passive - this option allows the device to act as an FTP client. The FTP server specifies a
random port number to be used for data transport.
• Active - this option allows the device to specify the return port to be used for data transport.
Note: Some network firewalls may not support Active mode.
5. Click on the [Apply] button to accept the changes.
6. Click on the [OK] button when you see the message “Properties have been successfully
modified”.
To Next Page
Loading...
Need help?
General
