Network Configuration
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
124
NTP
NTP (Network Time Protocol) is used to set the date and time of the system at start and every
subsequent 24 hour period, as well as any time the NTP parameters are modified. This feature ensures
that the device’s time stays synchronized with the NTP server specified.
If the device is configured to use DHCP, an NTP server, or the GMT offset is provided by the DHCP
server, then the data entered here will be overwritten by the corresponding DHCP retrieved items.
Note: Enabling NTP or modifying NTP settings will cause a system reset.
At Your Workstation:
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to Access Internet Services as System Administrator on page 24.
1. From the Properties tab, click on the [Connectivity] link.
2. Click on the [Protocols] link.
3. Select [NTP] in the directory tree.
4. In the Offset of Local Time Zone area:
a. From the drop-down menu, select the [Offset of Greenwich Mean Time] value. The default is
0.0 (Greenwich Mean Time).
5. In the Network Time Protocol area:
a. For NTP Enabled, check the [Enabled] checkbox to enable the protocol.
b. Select either [IPv4 Address] or [Host Name].
c. Enter details in the [IP Address: Port] or [Host Name: Port] field. The default port number is
123.
d. Enter details in the [Backup IP Address: Port] or [Backup Host Name: Port] field.
6. Click on the [Apply] button to implement any changes.
7. Click on the [OK] button when you see the message “Properties have been successfully
modified”.
To Next Page
Loading...
Need help?
General
