WorkCentreâ„¢ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
278
Select the Fax Country Setting
At the Device:
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to Access Tools Pathway as a System Administrator on page 18.
1. From the Tools pathway, touch [Service Settings].
2. Touch the [Fax Settings] to display the Embedded Fax Settings screen.
3. Touch the [Fax Country Setting], to display the Fax Country Setting screen.
4. Select the relevant country from the Country Selection list.
5. Touch [Save] to return to the Fax Settings screen.
Configuring Embedded Fax Settings
At the Device:
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to Access Tools Pathway as a System Administrator on page 18.
1. From the Tools pathway, touch [Service Settings].
2. Touch the [Fax Settings] to display the Embedded Fax Settings screen.
3. Select [Line Configuration] to display the Fax Line Setup screen.
a. Touch either [Line 1] or [Line 2] for Line Setup.
Note: Line 2 will be available if a Line 2 Fax Kit has been purchased and installed on the device.
b. Touch [Fax Number] type-in region and enter the fax number using the on-screen keypad.
c. Touch [Save].
d. Touch [Fax Line ID] type-in region and enter the Line Name using the on-screen keyboard. A
maximum of 30 characters can be entered.
e. For [Options], select one of the following options for sending and receiving fax:
• Send and Receive - the device is capable of sending and receiving fax transmissions.
• Send Only - the device is only capable of sending faxes.
• Receive Only - the device is only capable of receiving faxes.
f. For Dial Type, select either [Tone] or [Pulse].
g. Touch [Save] to return to Fax Settings screen.
Incoming Fax Defaults
Use this feature to configure settings for incoming faxes.
At the Device:
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to Access Tools Pathway as a System Administrator on page 18.
1. From the Tools pathway, touch [Service Settings].
2. Touch the [Fax Settings].
To Next Page
Loading...
Need help?
General
