dc10cc0466
Customer Support Page 6
BANNER SHEET (START SHEET)
PJL
@PJL SET JOBATTR= “@BANR=value”
Where value is one of the following:
START = start sheet
DEVICE = depend on device setting
OFF = no banner sheet
COPIES
Use this command to specify the number of non-collated sets of a document in a print job.
PJL PCL
@PJL SET COPIES = int <ESC>&l intX
Where int is 1 to 999.
QUANTITY
Use this command to specify the number of collated sets of a document in a print job.
PJL
@PJL SET QTY = int
Where int is 1 to 999.
SIMPLEX / DUPLEX PRINTING
This command specifies if a job is to print on one side or both sides of the sheet.
PJL PCL
@PJL SET DUPLEX = value1
@PJL SET BINDING = value2
<ESC>&l int S
Where value1 is one of the following:
ON = Duplex
OFF = Simplex
Where value2 is one of the following:
LONGEDGE
SHORTEDGE
(value2 is used combined with value1=ON)
Where int is one of the following:
0 = simplex
1 = Duplex Long Edge Binding
2 = Duplex Short Edge Binding
To Next Page
Loading...
