The UID button/indicator helps identify and locate a
device.
UID indicator:
⚫
Off: The device is not being located.
⚫
Blinking or steady blue: The device is being
located.
UID button:
⚫
You can control the UID indicator status by
pressing the UID button or using the iBMC.
⚫
You can press this button to turn on or off the
UID indicator.
⚫
You can press and hold down this button for 4 to
6 seconds to reset the iBMC.
Indicates the status when the iBMC direct connect
management port connects to a terminal (local PC or
Android mobile phone):
⚫
Off: No terminal is connected.
⚫
Blinking green at short intervals for 3 seconds and
then off: The port is disabled.
⚫
Steady green: The terminal is connected.
Indicates the status when the iBMC direct connect
management port connects to a USB device:
⚫
Blinking red at long intervals: The job fails or an
error is reported when the job is complete.
⚫
Blinking green at short intervals: The job is being
executed.
⚫
Blinking green at short intervals for 3 seconds and
then off: The port is disabled.
⚫
Steady green: The server configuration file is
being copied from the USB device or the job is
successfully completed.
To Next Page
Loading...
Need help?
General
