100
Source Impedance — Active Balanced (Ohms) < 60
Minimum Load (Ohms)
600
Maximum Output Level (dBu) +18
ADC, DAC and DSP sample rate (kHz)
96
AES accepted sample rates (kHz) 32-192
Dynamic Range (20Hz-20kHz Unwtd, dB) >114
Distortion (@1kHz, +10dBm, %) <0.001
Signal Processing
Delay up to 650mS (inputs), 650ms(outputs) - independant
Filters Parametrics — 8 Per input / 9 per output
Each parametric can be switched to Bandpass, Allpass, Notch, VariQ,
Shelf and Elliptical response
Phase filtering — 2 degree steps on each input and output
FIR Filtering — available on all outputs — total maximum taps available: 4000*
Crossover Filters (per output)
Bessel / Butterworth 6/12/18/24/48dB per octave and Linkwitz-Riley 12/24/48dB per octave
Dynamic EQ**
3 bands (per input)
Parametric behaviour — 19.7Hz — 32kHz
‘Q’ 0.4 — 128,
Max gain automatic gain adjustment 18dB
Max ratio (cut above mode) 4:1
Max ratio (all other modes) 2:1
Attack 70uS — 2.0 Seconds
Release 11mS — 3.4 Seconds
Mix matrix mode (auxes and amplifier outputs)
Input sends to each output continuously variable from -40.0dB to _15.0dB in 0.1dB steps plus mute
Limiter
Threshold +18dBu to -12dBu (auxiliary outputs); +42dBu to +20dBu (amplifier outputs)
Attack time 0.1 to 91 milliseconds
Release time 2, 4, 8, 16 or 32 times the attack time
Clip/D-max Limiter
Look-ahead attack time,Fast, Medium or Slow release times
*FIR Filtering enabled in later firmware release — 4000 taps with DEQ globally disabled
** DEQ enabled in later firmware release
To Next Page
