Xtralis ADPRO PRO E - Page 22

Installation Guide ADPROPROE by Xtralis
16 27386_05
9. Feed all cables through the seal as shown, based on their diameter.
CAUTION:
If you have erroneously removed one groove too many from the cable seal, close it with a piece
of cable remnant of appropriate diameter to maintain IP 65 rating.
10. Now insert the cable seal with the cables fixed in it into the housing so that it interlocks as shown. Check
that the seal is seated correctly with a positive fit.
Power Supply
CAUTION:
l It is recommended to use an EN50131-6 compliant power supply.
l The minimum voltage at the detector should not fall below 11.7 VDC in any operating
condition.
l For PRO E-detectors of version "H”, heating power consumption must be considered when
defining the main power supply.