NOTE: If pump is removed from operating area and disconnected from piping,
proceed to step 20. If the pump is not disconnected from its piping, follow Bearing
and bearing housing assembly on page 79 and lower the entire rotating assembly,
including bearing housings, into the pump. Once lowered into the pump, fasten the
bearing housing to the pump casing. See the next two images for rotating assembly
installation with bearing housings.
20.Lift the rotating assembly and install it within the lower casing. Ensure all pins rest
within their respective grooves.
6 Maintenance
e-XC INSTRUCTION MANUAL 69
To Next Page
Loading...
