Torque values
Control terminal
Torque value 0.8 Nm (7.00 lb in)
Power terminal
Drive size Nm lb in
2 1.0 8.85
3 1.0 8.85
4 4.0 3.00
5 15.0 11.10
6 20.0 15.00
Optional modules
Torque value 0.5 Nm (4.50 lb in)
Install the system
Requirements
• The mechanical installation of pumps, switch, and sensors is completed.
• The pumps that are installed must be equipped with FLS, thermal contacts. If no FLS is
used the P1-22:Leakage alarm setup parameter must be set to 0: Off.
• The pumps must be installed with screened cables.
• Do not install any type of automatic switchgear between the drive and the motor.
Install a two pump system
1. Prepare the drives cable throughlet.
Electrical Installation
SRC 311 - SmartRun
™
Installation, Operation, and Maintenance Manual 21
To Next Page
Loading...
