Xylem hydrovar Instruction Manual

42
G
G
24
24 ENABLE DEVICE
Enable – Disable of the selected device
Enable
Possible settings: Enable - Disable
Allows the drive to be be enabled or disabled by an external switch between X3 7 and 8. (Either in cascade
relay / serial / synchron or controller mode).
25
25 MOTOR HOURS
Runtime of the selected drive
XXXXX h
Total number of hours the motor has run. To reset see parameter CLR MOTORH. [1130].
Error memory
All errors, including those occuring on Basic Inverters are saved on the Master Inverter in this menu. The
errors saved in this menu include the failure message text of the drive where the failure happened, and the
date and time when the failure occurred. (For more information about errors, see chapter 10 failure mes-
sages.)
26
26 1st ERROR
Most recent error on the selected drive
ERROR XX
Message: ERROR XX, FAILURE TEXT, DATE, TIME
Press ▲ or ▼ to scroll up or down!
27
27 2nd ERROR
2nd most recent error on the selected drive
ERROR XX
Message: ERROR XX, FAILURE TEXT, DATE, TIME
Press ▲ or ▼ to scroll up or down!
28
28 3rd ERROR
3rd most recent error on the selected drive
ERROR XX
Message: ERROR XX, FAILURE TEXT, DATE, TIME
Press ▲ or ▼ to scroll up or down!
29
29 4th ERROR
4th most recent error on the selected drive
ERROR XX
Message: ERROR XX, FAILURE TEXT, DATE, TIME
Press ▲ or ▼ to scroll up or down!
30
30 5th ERROR
5th most recent error on the selected drive
ERROR XX
Message: ERROR XX, FAILURE TEXT, DATE, TIME
Press ▲ or ▼ to scroll up or down!
G
G
G
G
G
S
PROGRAMMING

Xylem hydrovar Specifications

General

Frequency	50/60 Hz
Control type	Variable speed drive
Protection class	IP55
Communication protocols	Modbus
Relative Humidity	5% - 95% (non-condensing)
Altitude	Up to 1000 m without derating
Input voltage	200-690 V AC
Storage Temperature	-25°C to +70°C (-13°F to 158°F)