43
G
G
G
G
G
G
40
40 SUBMENU
DIAGNOSTICS
41
41 PROD. DATE
production date of the HYDROVAR (Master/Single only)
XX.XX.XXXX
In the following parameters the current temperature, voltage and frequency of the chosen HYDROVAR can
be monitored during operation of the unit. These parameters are read only!
42
42 SEL. INVERTER
Select the desired unit
* 1 *
Possible settings: 1-8
43
43 TEMP. INVERTER
Temperature of the selected unit
XX % XX°C
The current value determines the temperature inside the selected HYDROVAR and is shown in °C and also
in percent of the maximum allowed temperature.
44
44 CURR. INVERTER
Current of the selected unit
XXX %
This value determines the output current of the HYDROVAR in percent to the maximum rated current
output.
45
45 VOLT. INVERTER
Input Voltage of the selected unit
XXX V
This value displays the input voltage supplied to the HYDROVAR.
46
46 OUTPUT FREQ.
Output frequency of the selected unit
XX.X Hz
This value displays the output frequency generated by the HYDROVAR.
47
47 VER. INVERTER
Software version of the selected drive
01
This parameter displays the software version of the BASIC drive (located on the main board).
Possible indications:
00 All power sizes (2-15 HP) prior production 05/2008
01 Sizes HV 2 - 5 HP - related to control board software V01.3
02 Sizes HV7.5 - 15 - related to control board software V01.3
PROGRAMMING
To Next Page
Loading...
Need help?
General
