FT-920 Operating Manual
31
(34) Memory Channel Display Field
This area of the display indicates the Memory Chan-
nel number.
(35) [O
FFSET]
This icon is illuminated when the Multi-Display Panel
is displaying the frequency offset of the Clarifier.
(36) VFO-B Mode
These icons display the operating mode in use on
VFO-B.
(37) [S
CAN]
This icon will be illuminated, during Memory opera-
tion, when the currently-selected Memory Channel
has been tagged for inclusion among the channels
to be scanned.
(38) [R
X] [TUNER] [TX]
These icons light up to indicate whether the Auto-
matic Antenna Tuner is connected to the Receiver or
Transmitter stage, respectively.
(39) [CAT]
This icon will be illuminated when data is being passed
to or from the transceiver’s (serial) DATA port. Dur-
ing operation using software which “polls” the radio’s
status frequently, this icon may appear to be blink-
ing.
(40) VFO-B Frequency Display
This is the main frequency display for the transceiver’s
secondary (B) VFO. Display resolution to 10 Hz is
provided.
(41) [L
OCK]
This icon is illuminated when the VFO-B “Lock” func-
tion is activated so as to prevent inadvertent frequency
changes.
(42) [BK-IN]
During CW operation, this icon will be illuminated if
Full Break-In (QSK) operation is selected.
(43) [KEYER]
This icon is illuminated, in the CW mode, when the
built-in Electronic Keyer is turned on.
(44) [TRACK]
This icon will be illuminated during “VFO Tracking”
operation, whereby VFO-A and VFO-B are “slaved”
under control by the VFO-A Tuning Knob (press and
hold in the VFO-A [LOCK] key while rotating the tun-
ing dial to engage VFO Tracking).
(45) [NR]
This icon is illuminated when the DSP Noise Reduc-
tion circuitry is active.
To Next Page
