Battery Charger (Accusense by DPI
®
)
DESCRIPTION
Some lift trucks are equipped with DPI
®
brand battery
chargers. DPI Gen II chargers and DPI Gen III charg-
ers differ slightly and can be distinguished by their ap-
pearance. See Figure 26 and Figure 27. DPI chargers
are self contained, 120 volt, AC powered chargers.
Each charger comes equipped with a short lead plug
to allow connection to the 120 volt AC outlet using a
20 amp rated extension cord. The charger will operate
from any wall outlet capable of supplying 108 to 126
volts AC protected by a 20 amp circuit breaker.
Figure 26. DPI Gen II Chargers
1. USB PORT (FACTORY USE ONLY)
2. MODE PORT DIP SWITCHES
Figure 27. DPI Gen III Chargers
NOTE: Some markets use a special 230 volt AC
charger which require connection to a 230 volt AC
outlet. Users with 230 volt AC chargers should substi-
tute 230 volts AC in the place of 120 volts AC when
instructed to connect the charger to a power source.
OPERATION
LED Display
The charger has five colored LEDs located on the top
of the charger. The LEDs are used to indicate the sta-
tus of the charger during operation. The order of the
LEDs may vary with models, but are labeled to iden-
tify their function. See Table 2.
Battery Charger (Accusense by DPI
®
)
2200 YRM 1007
36
To Next Page
Loading...
Need help?
General
