EasyManuals Logo

Yale B827 User Manual

Yale B827
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Battery Pack Troubleshooting
WARNING
Disconnect the charger from the AC power source
before proceeding.
Always wear protective gear including eye protec-
tion and suitable gloves when servicing battery
packs.
NOTE: For general information about battery mainte-
nance and procedures, refer to Industrial Battery
2240YRM0001.
1. Measure the specific gravity (SG) level for each
battery cell (after a charging cycle).
After a charging cycle, the SG measurement for each
cell should be 1.265 or greater.
From cell to cell within one battery: The SG measure-
ments should not vary more than 0.020. If variance is
greater than 0.020, it is recommended that the battery
be replaced with the same type of battery as the other
three batteries in that pack.
From battery to battery within one battery pack: The
SG measurements should not vary more than 0.050.
If one of the batteries has an SG reading 0.050 below
the other three batteries and the voltage is less than
6.3VDC after allowing the batteries to set four hours
without any load, it is recommended that the battery
with lowest SG be replaced with the same type of bat-
tery as the other 3 batteries in that pack.
WARNING
DO NOT overfill battery cells.
2. Verify water level in each cell of each battery:
Before Charging: Only add minimal amount
of distilled water to cover top of plates if
needed.
After Charging: Add distilled water as nee-
ded to fill to the bottom of cell opening.
3. Battery Replacement: Each battery manufacturer
has a specific "charge set-up" that will give your
truck the best battery life and drive time for your
truck. If the "charge set-up" is not correct, you can
damage the batteries and will not get the full per-
formance you expect. Make sure that the battery
charger is set to the proper charging mode for
your battery pack.
DO NOT mix manufacturers or battery
types in the power pack
It is not recommended to change out bat-
teries independently. All batteries should
be changed together when battery pack is
updated.
2200 YRM 1007
Battery Charger (Accusense
®
20A)
53

Table of Contents

Other manuals for Yale B827

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yale B827 and is the answer not in the manual?

Yale B827 Specifications

General IconGeneral
BrandYale
ModelB827
CategoryLifting Systems
LanguageEnglish

Related product manuals