RX-V2500/DSP-AX2500
19
RX-V2500/
DSP-AX2500
No DIAG MENU SUB MENU
12 AD DATA CHECK / FAN TEST 1. PS (protection)
2. DC (protection) / FAN OUT
3. TH
4. REC-OUT
5. PL
6. K0 / K1 (panel key)
7. FAN DRIVE TEST: HIGH (
Fan test only applies to models with a fan. /
ファン装備モデルに適用
)
8. FAN DRIVE TEST: MID (
Fan test only applies to models with a fan. /
ファン装備モデルに適用
)
9. FAN DRIVE TEST: LOW (
Fan test only applies to models with a fan. /
ファン装備モデルに適用
)
13 V CONV STATUS 1. LOW BYTE DATA
2. HIGH BYTE DATA
14 IF STATUS 1. IS 1 (5 Byte)
2. IS 2 (3 Byte)
3. CS 1 (5 Byte)
4. CS 2 (5 Byte)
5. CS 3 (4 Byte)
6. BS 1 (5 Byte)
7. BS 2 (5 Byte)
8. BS 3 (5 Byte)
9. BS 4 (3 Byte)
10. TI 1 (5 Byte)
11. TI 2 (1 Byte)
12. MTT (5 Byte)
15 BUS CHECK 1. YSS930 BUS CHECK
2. SECOND DECODER BUS CHECK
3.YGV619 BUS CHECK
16 PROTECTION SET (Not applied to this model. / このモデルには適用されません)
17 SOFT SW 1. SW MODE
CHANGE SW BY EFFECT KEY 2. MODEL SETTING
3. TUNER DESTINATION
4. TUNER EXIST
5. RDS EXIST
6. ZONE 2 EXIST
7. VIDEO FORMAT
18 ROM VERSION / SUM / PORT 1. VERSION (DSP ALL)
2. VERSION (OPERATION / GUI / DSP)
3. SUM (ALL / AFTER BOOT)
4. SUM (232C BOOT / MAKER BOOT)
5. SUM (CDDA BOOT / BIT MAP, FRONT)
6. SUM (WALL PAPER 1 / WALL PAPER 2)
7. SUM (PROGRAM)
8. PORT
9. AAC PORT
To Next Page
Loading...
Need help?
General
