Yamaha F60A - Page 105

105 pages

Save Page as PDF

To Previous Page

YAMAHA MOTOR CO., LTD.

Printed in the Netherlands

Jul. 2001 – 1.3 × 1 CR

(F60AEHT, F60AET)

(E)

Main Page

Default Chapter2
- Important Information2
- Table of Contents4
How to Use this Manual8
- Manual Format8
- Symbols9
- Contents9
- General Information8
Identification10
- Applicable Models10
- Serial Number10
Features and Benefits11
- Power Unit11
- Carburetors12
- Lower Unit14
- Bracket Unit16
- Electrical Unit17
Technical Tips18
- Carburetor18
- PTT (Power Trim and Tilt) Unit19
Propeller Selection20
- Propeller Size20
- Selection20
Predelivery Checks21
- Checking the Fuel System21
- Checking the Gear Oil21
- Checking the Engine Oil21
- Checking the Battery21
- Checking the Outboard Motor Mounting Height21
- Checking the Shift/Throttle Cables22
- Checking the Steering System22
- Checking the Gearshift and Throttle Operation23
- Checking the Tilt System23
- Checking the Engine Start Switch and Engine Stop Switch/Engine Shut-Off Switch23
- Checking the Cooling Water Pilot Hole24
- Test Run24
- Break-In24
- After Test Run24
General Specifications25
Maintenance Specifications27
- Power Unit27
- Lower Unit31
- Electrical31
- Dimensions34
Tightening Torques39
- Specified Torques39
- General Torques40
Special Service Tools41
Maintenance Interval Chart43
Top Cowling44
- Checking the Top Cowling44
Fuel System44
- Checking the Fuel Filter44
Power Unit44
- Checking the Thermostat44
General45
- Checking the Anodes45
- Lubrication46
Hose Routing47
- Fuel and Blowby Hoses47
- Cooling Water Hose48
Fuel Line and Fuel Filter49
Carburetor Unit50
- Adjusting the Dashpot (Acceleration Pump)51
Power Unit52
- Checking the Compression Pressure62
- Checking the Oil Pressure62
- Checking the Cylinder Bore63
- Checking the Piston Ring Grooves63
Drive Shaft and Lower Case64
- Removing the Drive Shaft66
- Disassembling the Forward Gear66
- Assembling the Forward Gear66
- Installing the Drive Shaft66
Lower Unit64
Shimming67
- Shimming68
- Selecting the Forward Gear Shims68
Tiller Handle70
Bracket Unit70
Bottom Cowling72
Upper Case74
- Disassembling the Oil Pan78
- Assembling the Oil Pan78
- Installing the Upper Case79
Clamp Brackets81
- Adjusting the Trim Sensor82
Swivel Bracket and Steering Arm83
Power Trim and Tilt Unit84
- Disassembling the Gear Pump89
- Checking the Valves89
- Assembling the Gear Pump90
- Checking the Trim Sensor91
Wiring Harness92
- Electrical Systems92
Ignition and Ignition Control System93
- Checking the Spark Plug Caps95
- Checking the Pulser Coil Air Gap95
- Checking the Engine Start Switch95
Starting System96
Starter Motor97
- Checking the Armature98
- Checking the Brushes98
Wiring Diagram101

Yamaha F60A - Page 105

Table of Contents

Other manuals for Yamaha F60A

Related product manuals