6-38
Outboard Rigging Guide - 2001 F40 4-Cyl., F/T50 Tiller Handle Kit
6. Check the steering movement for smooth
operation.
NOTE:With the friction lever turned fully to the
right, check the tiller for smooth movement.
7. Install the fuel hose 1.
F it the fuel hose into the clamp securely.
8. Install the battery lead 2 and extension wire
harness 3 under the shift cable
a and throt-
tle cable
b.
NOTE:Set the battery lead 2 and extension
wire harness 3 under the shift cable a and throt-
tle cable
b.
9. Install the screw 4.
Completion Check
Static Check
1. Check the shift operation. Make sure the shift
action is smooth for Forward, Neutral and
Reverse.
2. Check the throttle operation for smoothness
from fully closed to fully open.
NOTE:Shift forward and then check the throttle
operation.
3. Check steering friction to make sure proper
friction is obtained. Move the tiller handle tilt
up/down and check that the cables and wires
are not stretched.
4. Check the power trim/tilt switch.
a. Connect the battery.
b. Push and hold the switch to “UP”, the
motor will tilt up.
c. Push and hold the switch to “DN”, the
motor will tilt down.
d. Release the switch, the motor will stop at
its current position.
To Next Page
