2-22
Outboard Rigging Guide - 2001 Jet Drive Eng. Mtg., Maintenance,
Shift Cable Instruction, Service Info.
90, V4 & V6 Models (Cont’d.)
REF
NO. DESCRIPTION QTY.
1 Jet Drive Assembly
2 Main Housing 1
3 Reverse Gate 1
4 Pivot Pin, Reverse Gate 2
5 Nylon Sleeve, Reverse Gate Pivot Pin 2
6 Bolt, Reverse Gate Fixing 2
7 Hose, Grease Exit 1
8 Fitting, Grease 1
9 Clamp Assembly, Exhaust Tube 2
10 Dowel Pin, 3/16" x 1/2" 2
11 Shift Cam 1
12 Bolt 1
13 Rod End 1
14 Shifter Bushing (not used '95 and later) 1
15 Nut, Fiber Lock 1/4-20 x 5/8" 1
16 Flat Washer 1/4" 1
17 Cam Eccentric Drilled 1
18 Bracket, Cable Support 1
19 Bolt, Bracket 1/4-20 x 5/8" 2
20 Flat Washer 1/4" 2
21 Clamp, Cable 1
22 Plate, Backing, Cable Clamp 1
23 Bolt, Cable Clamp 2
24 Locknut 2
25 Adapter Plate 1
26 Dowel Pin, 6mm x 16mm (65 Model) 2
26 Dowel Pin, 8 x 12mm (V4/V6) 2
27 Guide Pin, 3/8" x 1-1/2" (90) 1
27 Guide Pin, 1/4" x 2" (V4/V6) 1
28 Bolt, Adapter Plate 10 x 35mm
(90/V4-V6) 4/7
29 Bolt, Adapter Plate 3/8-16 x 1-1/4"
(90 Model) 1
29 Bolt, Adapter Plate 3/8-16 x 1-1/2"
(V4-V6) 8/12
30 Lock Washer M10 (90/v4-V6) 8/12
31 Intake Housing
('96 and earlier has screw-type liner
attachment, '97 and later has flange) 1
32 Intake Grille 1
33 Bolt, Intake Housing ('96 and earlier) 6
33a Stud, 3/8" ('97 and later) 6
33b Nut, 5/16-18 Nylock stainless steel
('97 and later) 6
34 Driveshaft 1
35 Woodruff Key, Driveshaft 1
36 Thrust Ring, Shaft Bearing 1
37 Nylon Sleeve, Impeller Bore 1
38 Special Key, Impeller 1
39 Impeller 1
40 Shim Impeller Adjustment 9
41 Tab Lock 1
REF
NO. DESCRIPTION QTY.
42 Locknut 1
43 Seal, Shaft Outer 2
44 Retaining Ring, Inner and Outer Seal 4
45 Seal, Shaft Inner 2
46 Bearing and Seal Housing 1
47 Bolt, Housing 5/15-18 x 1"
('97 and later)
Bolt, Housing 1/4-20 x 7/8"
('96 and earlier) 4
48 Lock Washer 1/4"
(use on '96 and earlier only) 4
49 Bearing 2
50 Thrust Washer 1
51 Bolt, Adapter Plate 3/8-16 x 3" 1
52 Bolt, Adapter Plate 3/8-16 x 2-3/4" 1
53 Upper Seal Carrier 1
54 O-Ring 2
55 Retaining Ring 4
56 Aluminum Spacer 1
57 Dowel Pin 2
58 Gasket 1
59 Steel Plate 1
60 Gasket 1
61 Impeller, Water Pump 1
62 Cartridge 1
63 Housing, Water Pump 1
64 Bolt, Housing 5/16-18 x 2-1/4"
(90/V4-V6) 2/4
65 Bolt, Housing 5/16-18 x 3-1/4" 2
66 Special "D" Washer 4
67 Bolt, Adapter Plate 3/8-16 x 2-1/4" 2
68 Shaft Roller 1
69 Roller Assembly 1
70 Washer 1
71 Nut, Nylon 2
72 Gate Bumper 1
73 Gate Assembly 1
74 Exhaust Tube 1
75 Screw, Flush 1
76 Washer, Flush 1
77 Nut, Jam (not used '95 and later) 1
78 Washer, Spring (not used '95 and later) 1
79 Nut, Hex (not used '95 and later) 1
80 Cam Bushing 1
81 Cam Washer 1
82 Cam Shim 1
83 Spring, Cam Bumper 1
84 U Bolt 1
85 Screw 1
86 Spring, Gate Pivot 1
87 Circlip 1
88 Bolt, Adapter Plate 8 x 30 1
To Next Page
Loading...
