2-37
CABLE ROUTING
1 Rear wheel speed sensor lead
2 P
lain washer
3 Br
ake hose union bolt
4 Rear
brake hose
5 Rear
brake hose holder
6 Bat
tery box
7 Fr
ame
8 F
ootrest assembly
9 Cl
amp
0 Rear
brake light switch lead
A Rear
brake master cylinder
B Spl
it pin
C Rear
brake reserve hose guide
D Rear
brake reserve hose
E Rear
brake caliper
F Rear
brake hose (ABS hydraulic unit to rear
brake caliper)
G Rear
brake hose (ABS hydraulic unit to rear
brake master cylinder)
È Fix the clamp on the paint mark of brake hose
pr
otector and white tape of wheel speed sensor.
É Air shall be completely removed.
Ê Clamp shall be inserted in the brake light switch
st
ay.
Ë Wheel sensor shall be clamped at white tape.
Ì Clamp shall be inserted in the hole of battery
box
.
Í Set the tip of the clamp as shown, cut the tip of
the
band, maximum length of band tip 5mm.
Î Adjust the brake light switch until brake light turn
“
on” before brake starts to be working.
Ï Install the spring hook into the brake pedal
sp
ring stay as shown.
Ð Pin shall be inserted from outside of the vehicle.
Ñ Reserve hose shall be assembled through the
c
lamp of plate.
Ò Rear brake hose shall be assembled to brake
ca
liper by touching right side.
Ó Brake hose shall be assembled by touching rear
mas
ter cylinder.
Ô Fit the clamp on white tape mark at wheel speed
se
nsor.
Õ Rear brake hose (ABS hydraulic unit to rear
br
ake caliper) shall be assembled.
B9X-F8197-E0.book Page 37 Thursday, July 16, 2020 2:28 PM
To Next Page
Loading...
