3-8
CHASSIS
ECA18060
Make sure that the main switch is turned to
“OFF” before checking the operation of the
hydraulic unit.
k. After operating the ABS, repeat steps (e)
to (i), and then fill the brake master cylin-
der reservoir or brake fluid reservoir to the
proper level with the specified brake fluid.
l. Tighten the bleed screw to specification.
m. Fill the brake master cylinder or brake fluid
reservoir to the proper level with the spec-
ified brake fluid.
EWA13110
After bleeding the hydraulic brake system,
check the brake operation.
Front brake caliper bleed screw
14 N·m (1.4 kgf·m, 10 lb·ft)
Rear brake caliper bleed screw
6 N·m (0.6 kgf·m, 4.4 lb·ft)
Specified brake fluid
DOT 4
B9X-F8197-E0.book Page 8 Thursday, July 16, 2020 2:28 PM