31
Acoustic Multi
Multi effect for electric-acoustic guitar.
Parameter Display Range Description
Mic Type TYPE
Condenser1, Condenser2,
Dynamic1, Dynamic2, Tube1,
Tube2, Nylon String1,
Nylon String2
Microphone simulator type
Blend BLND 0.0 to 10.0 Balance between mic simulator and direct sounds
Bass BASS -12.0 to 12.0 dB Low frequency level
Middle MID -12.0 to 12.0 dB Mid frequency level
Treble TRE -12.0 to 12.0 dB High frequency level
Presence PRE -12.0 to 12.0 dB Extremely high frequency level
Volume VOL 0.0 to 10.0 Volume
Stereo STE 0.0 to 10.0 Setting for stereo mic effect
Bass Freq. BASF 50 Hz to 400 Hz Frequency for low frequency EQ
Middle Freq. MIDF 200 Hz to 1.80 kHz Frequency for mid frequency EQ
Treble Freq. TREF 600 Hz to 4.80 kHz Frequency for high frequency EQ
Presence Freq. PREF 2.00 k to 16.0 kHz Frequency for extremely high frequency EQ
Limiter LMSW Off, On Limiter switch
Chorus/Delay ETYP Off, Chorus, Delay Effect type
Reverb Type RTYP Off, Hall, Room, Plate Reverb type
Limiter Level LIM 0.0 to 10.0 Limiter level
Speed/Time SP/T 0.0 to 10.0 Chorus effect speed/delay time
Depth/FB. D/FB 0.0 to 10.0 Chorus effect depth/delay feedback
Effect Level ELVL 0.0 to 10.0 Effect level
Reverb RLVL 0.0 to 10.0 Reverb level
What is TAP?
The “Tap” parameter found in delay effects is the timing at which the delay sound is taken out of the delay loop.
To illustrate this function, the delay shown below is using a delay time setting of 360msec. However, with the
“Tap” parameter set to 60, the first delay sound will be heard at 216msec. This happens for the first delay sound
only. If the Feedback (FB.) level is increased, all subsequent delay sounds will be heard at 360msec. intervals.
360msec
TAP=100%
216msec
TAP=60%
Delay Circuit
216
msec
360
msec
360
msec
TIME
Original Sound
First Delay Sound
Feedback Delay Sound
To Previous Page
Loading...
