Yamatake STD920 - Setting Message Format

Operation of the Transmitter Yamatake Corporation
5-68 ST3000 Smart Transmitter Series 900 Electronic Differential Pressure/Pressure Transmitter
5-13-3 :Setting message Format
Procedure
The following procedure can be used to check and set the message format “4-byte out-
put” or “6-byte output” shown in Table 5-3
Step Description SFC screen
1 Make sure that the transmitter is
in the ready state.
2
Press the key and then press
the key.
3
Press the key or key
to display next DE CONFIG
menu item-Message format selec-
tion.
4
Alternately press the key
until a desired message format
appears.
5
Press the key.
6
Press the key or key
until the message to the right is
displayed.
7
Press the key.
8 When this message displayed, the
SFC can be disconnected from the
transmitter.
DSTJ
READY...
PIC001
SHIFT
MENU
I
ITEM
DE CONF.
SHIFT-
SHIFT-
DECONFIG
DOWNLOAD DATA?
H
NEXT
L
PREV
DECONFIG
DE-6 Byte
MENU
I
ITEM
DE CONF.
DECONF
DE-4 Byte
ENTER
( Yes )
NON-VOL
DECONFIG
ENTERED IN SFC
H
NEXT
L
PREV
DECONFIG
DOWNLOAD DATA?
ENTER
( Yes )
NON-VOL
DECONFIG
WORKING...
DSTJ
READY...
PIC001