PRODUCT OVERVIEW
28 JH Series Operation Manual
Setup screen access and control
(Setting the temperature and pressure units and engine speed pulse)
Use the buttons on the bottom of the LCD
display to set the instrument panel.
Press the left button to switch between displays.
Press and hold both buttons until "SET
UP" appears.
Press the left button to set the units for
the temperature and pressure display.
Setting the temperature and pressure units
The display says "UNIT".
Next, press the right button to select
Metric units (°C, BAR). The display
says "METRIC".
Press the left button to switch to Imperial
units (°F, PSI). The display says "ENGL".
Press the right button to select and go
back to the "UNIT" screen.
Press the left button and go to the next
screen "ENGINE".
Confirm that the display says "ENGINE".
Pressing the right button shows the screen
for the engine speed pulse setting.
Setting the engine speed pulse value
Confirm that the display says "ENGINE".
Press the right button and "P****" appears.
Note:
The pre-set value of speed pulse is
indicated on the box of each panel.
Next, press the left button and select the
speed pulse value for each engine model.
After confirming the value is changed
correctly, press the right button to
return to the “ENGINE” screen.
Press the left button again to go from the
"ENGINE" screen to the "EXIT" screen.
After confirming the display, press the
right button to re-start the panel and
return to the hourmeter display.
Figure 2
Figure 16
Engine model Speed pulse value
JH with HITACHI alternator
10.29
JH with VALEO alternator 12.10
055129-00EN00
1 2
14
4
2 3
1
5
2 3
Engine type select
Select
Scroll
Imperial Metric
Select
Select
Exit setup
Select
Scroll
Return to previous
page LCD control
Scroll
03-Product Overview.fm 28 ページ ２０１３年９月１２日 木曜日 午後１２時４分
To Next Page
Loading...
