3-10
165559-1CD
HW1481993
DX200 Standard Setup
3 Programming Pendant Setup
3.2 Setting Up the Programming Pendant
3. While pressing [2], [8], and [HIGH SPEED] simultaneously, turn ON
the DX200 main power supply. Release the keys when the bit-map
image appears on the programming pendant screen or a buzzer
sounds.
4. NK.BIN (OS: WindowsCE.5.0) in the CF is written into the internal
memory (FlashRom) of the programming pendant from SDRAM. At
this time, the LED indicators blink as follows:
Bit-map image appears.
Press [2], [8], and [HIGH
SPEED] simultaneously.
The four LED indicators blink clock-
wise. The blinking cycle is irregular.
(The indicators sometimes blink every
one to two seconds, or sometimes
four to five seconds.) It takes approx.
three minutes to transfer the data.
The three LED indicators blink clock-
wise, every one to two seconds. It
takes approx. four minutes to write-in
the data.
Total time required for transfer and write-in is approx. ten minutes.
<While NK.BIN is being transferred
from CF to SDRAM>
<While NK.BIN is being written into
FlashRom from SDRAM>
To Next Page
Loading...
