YASKAWA FSDrive-MV1S - Page 52

Modes
3-9
Setting User Constants
Here, the procedure is shown to change C1-01 (Acceleration Time 1) from 10 s to 20 s.
Table 3.3 Setting User Constants in Advanced Programming Mode
Step
No.
Digital Operator Display Description
1
Power supply turned on.
2
MENU key pressed to enter drive mode.
3
MENU key pressed to enter quick programming mode.
4
MENU key pressed to enter advanced programming mode.
5
DATA/ENTER Key pressed to access monitor display.
6
Increment or Decrement Key pressed to display C1-01 (Acceleration Time 1).
7
DATA/ENTER Key pressed to access setting display. The setting of C1-01
(10.00) is displayed.
8
Shift/RESET Key pressed to move the flashing digit to the right.
9
Increment Key pressed to change set value to 20.00 s.
10
DATA/ENTER Key pressed to enter the set data.
“Entry Accepted” is displayed for 1.0 s after the data setting has been
confirmed with the DATA/ENTER Key.
11
The monitor display for C1-01 returns.
U1-02=60.00Hz
U1-03=10.1A
-DRIVE- Rdy
Frequency Ref
U1- 01 =100.00%
Operation
INV * MODE sel *
-DRIVE-
Quick Setting
INV * MODE sel *
-QUICK-
Programming
INV * MODE sel *
-ADV-
Access Level
Initialization
-ADV-
A1 -01=2
(0.0 to 6000.0)
“10.0sec”
-ADV-
Accel Time 1
C 1- 01 =10.0sec
(0.0 to 6000.0)
“10.0sec”
-ADV-
Accel Time 1
C1-01= 0 010.0sec
(0.0 to 6000.0)
“10.0sec”
-ADV-
Accel Time 1
C1-01=00 1 0.0sec
(0.0 to 6000.0)
“10.0sec”
-ADV-
Accel Time 1
C1-01=00 2 0.0sec
Entry Accepted
-ADV-
(0.0 to 6000.0)
“10.0sec”
-ADV-
Accel Time 1
C1- 01 =20.0sec