YASKAWA FSDrive-MV1S - Advanced Programming Mode

3-8
 Advanced Programming Mode
In advanced programming mode, all Inverter constants can be monitored and set.
Constants can be changed from the setting displays. Use the Increment, Decrement, and Shift/RESET Keys to
change the frequency. The user constant will be written and the monitor display will be returned to when the
DATA/ENTER Key is pressed after changing the setting.
Refer to Chapter 5 User Constants for details on the constants.
Example Operations
Key operations in advanced programming mode are shown in the following figure.
Fig 3.5 Operations in Advanced Programming Mode
Programming
INV * MODE sel *
-ADV-
Tuning Mode
INV * MODE sel *
-A TUNE-
Operation
INV * MODE sel **
-DRIVE-
Monitor Display
Mode Selection Displa
y
Quick Setting
INV * MODE sel *
-QUICK-
Setting Display
MENU
A B
1 2
MENU
MENU
ESC
DATA
ENTER
ESC
DATA
ENTER
RESET
ESC
(0 to 9999)
“2”
-ADV-
Access Level
ESC
DATA
ENTER
(0 to 9999)
“2”
-ADV-
Access Level
Access Level
Initialization
-ADV-
A1 -01=2
1 2
IM VEC. PG-Less
“0”
-ADV-
Control Method
IM VEC. PG-Less
“0”
-ADV-
Control Method
*2*
Control Method
Initialization
-ADV-
A1 -02=2
3 4
ESC
DATA
ENTER
RESET
ESC
(0 to 300)
“200%”
-ADV-
Torq Limit Fwd
ESC
DATA
ENTER
(0 to 300)
“200%”
-ADV-
Torq Limit Fwd
Torq Limit Fwd
Torque Limit
-ADV-
L7 -01=200%
3 4
(0.0 to 100.0)
“0.5%”
-ADV-
Torq Lmt Rev Rgn
(0.0 to 100.0)
“0.5%”
-ADV-
Torq Lmt Rev Rgn
A B
Torq Lmt Rev Rgn
Torque Limit
-ADV-
L7 -04=0.5%
MENU
RESET
ESC
RESET
ESC
Fault History
INV * MODE sel *
MENU
L7- 04 =0.5%
L7- 01 =200%
A1- 01 =2
A1-
02 =2 *2*
A1-01= 0 002
A1-02= 2
*2*
L7-04= 0 00.5%
L7-01= 2 00%